Easy Operating Metallurgical Mounting Press Machinery With CE Qualified

Easy Operating Metallurgical Mounting Press Machinery With CE Qualified

Brief Introduction:

iPress-889 was used to inlay the small and irregular specimens, to ensure these specimens were easily holding to cut, grind and polish, then to do metallographic analysis, spectral analysis or hardness testing.

The unit was controlled by micro computer, and can realize automatically heating, pressure loading, cooling and unloading the full mounting process. With the advantages of humanization design, easy operation, high efficiency.

Technical Specifications:

Mounting of specimens is usually necessary to allow them to be handled easily. It also minimizes the amount of damage likely to be caused to the specimen itself.

The mounting material used should not influence the specimen as a result of chemical reaction or mechanical stresses. It should adhere well to the specimen, and if the specimen is to be electropolished later in the preparation then the mounting material should also be electrically conducting.

Specimens can be hot mounted (about 150 °C) using a mounting press either in a thermosetting plastic, e.g. phenolic resin, or a thermosoftening plastic e.g. acrylic resin. If hot mounting will alter the structure of the specimen a cold-setting resin can be used, e.g. epoxy, acrylic or polyester resin. Porous materials must be impregnated by resin before mounting or polishing, to prevent grit, polishing media or etchant being trapped in the pores, and to preserve the open structure of the material.

A mounted specimen usually has a thickness of about half its diameter, to prevent rocking during grinding and polishing. The edges of the mounted specimen should also be rounded to minimize the damage to grinding and polishing discs.

metallurgical laboratory equipment

metallurgical sample preparation equipment

Easy Operating Metallurgical Mounting Press Machinery With CE Qualified Images